Plywood Boat Plans
Today, the inwales were fitted and slid in from the stern and the inside of the ama was coated. With the inwales in the temporary gunwales used to pull the sides in could be removed. I weighed the side panels and bulkheads pre-torturing at just under 30lbs. I expect that with epoxy coating, bottom paint, crossbeam structure, dagger trunk and a deck it will easily finish up around 40 which would be ok with me. 45 would be less ok but whatever it comes out at, "ill own it" as they say.
This time I glued in the bulkheads near the keel pre-torture and that caused the hull to be a little less fair than I would have liked but its rock hard now so no going back. I dont plan to make changes for the port ama. Its not that bad.
You can see that I went for the inverted bow, wave piercer ama shape with influences from the Nacra Infusion, and Seacart 26 tri.
Apologies for the quality of the pictures. the shop is dimly lit at night.
Do you find information about Plywood Boat Plans are you looking for? If not, below may help you find more information about the Plywood Boat Plans. Thank you for visiting, have a great day.
0 komentar:
Posting Komentar